DIY T-Light Holder by Tanvi
Hello & welcome here again!
This is Tanvi, sharing my inspiration for Rinea with Floracraft foam square, a quick & easy DIY LED T-light holder.
Using a craft knife carefully sculpt a round on one side of the cube, the size of the LED T light. It is easy peasy to do this.
Next cut 5 pieces of 3x3" with glossy gold foil from the metallics variety pack. I used mod podge to glue these onto the cube. Leave it for a few hours to cure.
Using a very intricate rose die, die cut four pieces (Glossy Copper/Copper). Use these to decorate the prepared cube & the holder is ready! I used liquid enamel accents along the edges.
Here is the completed project -
